Letters
Testing Single Posts vs. Railing Assemblies
The president of a post-anchor manufacturing company weighs in on load testing of guardrail posts and assemblies
2 MIN READ
Mike Guertin
-
-
Letters
Attaching Posts to 2×6 Framing
1 MIN READ
-
Letters
Field-Treating Pressure-Treated Pine
1 MIN READ -
Q&A
Rules for Mid-Stair Landings on Decks
3 MIN READ
-
Q&A
Integrating Headers into the Floor Framing
3 MIN READ![a. Spans are given in feet and inches.
b. Table is based on a maximum roof-ceiling dead load of 15 psf.
c. The header [may] be supported by an approved framing anchor attached to the full-height wall stud [...]in lieu of the required jack stud.
d. The 20 psf ground snow load condition shall apply only when the roof pitch is 9:12 or greater [...]
e. Building width is measured perpendicular to the ridge. For widths between those shown, spans [may] be interpolated.
f. The header shall bear on a min. of one jack stud at each end.](https://jlconline.stg.zonda.onl/wp-content/uploads/sites/4/2014/0714-jlc-qa-header-tcm96-2152451.jpg?w=227)
-
-
Tools
Diablo Demo Demon Carbide Tip Recip Blades
2 MIN READ
-
Q&A
Flashing a Curved Window With Straight Flashing
3 MIN READ
-
How To
JLC June Letters
4 MIN READ -
Letters
JLC May Letters
4 MIN READ